mindstorm 0.5.4 · OCaml Package

Ultrasonic sensor. Convenience functions to interact with the ultrasonic sensor through the I2C protocol.

type 'a t

Represent an initialized ultrasonic sensor connected to a given port.

val make : 'a conn -> port -> 'a t

make conn port initialize the sensor on port port as being an ultrasonic one.

val set : 
  ?check_status:bool ->
  'a t ->
  [ `Off
  | `Meas
  | `Meas_cont
  | `Event
  | `Reset
  | `Meas_interval of int
  | `Zero of int
  | `Scale_mul of int
  | `Scale_div of int ] ->
  unit

Ultrasonic.set us cmd set the state or parameters for the ultrasonic sensor us. cmd may be:

`Off: turns the ultrasonic sensor off.
`Meas: single shot command. In this mode, the ultrasonic sensor will only make a new measurement every time the command byte is send to the sensor. The sensor will measure distances for up to 8 objects and save the distances within the `Byte0 .. `Byte7 variables.
`Meas_cont Continuous measurement command. This is the default mode, where the sensor continuously makes new measurement with the specified interval (see `Meas_interval below).
`Event: Event capture command. Within this mode the sensor will measure whether any other ultrasonic sensors are within the vicinity. With this information a program can evaluate when it is best to make a new measurement which will not conflict with other ultrasonic sensors.

`Meas_interval t: set continuous measurment interval.
`Zero z: set the actual zero.
`Scale_mul m: set the actual scale factor.
`Scale_div d: set the actual scale divisor.

`Reset: resets the ultrasonic sensor.

parameter check_status
check the return status. Exceptionally, the default is true because the sensor needs to time to set itself up anyway and this avoids Mindstorm.Buffer_full errors if we try to get values from the sensor.

val get : 
  'a t ->
  [ `Byte0
  | `Byte1
  | `Byte2
  | `Byte3
  | `Byte4
  | `Byte5
  | `Byte6
  | `Byte7
  | `Meas_interval
  | `Zero
  | `Scale_mul
  | `Scale_div ] ->
  int

Ultrasonic.get us var returns the content of the variable var on the sensor (detailed underneath). All values are between 0 and 255. Communication errors will be reported by raising Error Bus_error; your application should be ready to handle such exceptions.

`Byte0 .. `Byte7 are the 8 variables containing the distances measured with the `Meas or `Meas_cont command (in centimeters).

`Meas_interval returns the interval (in 0.01 sec) between two consecutive measurments when the sensor is in continuous measurment (command `Meas_cont).

`Zero returns the value of the actual zero (settable with the `Zero command).

`Scale_mul (resp.�`Scale_div) return the current scaling factor (resp.�divisor). It is settable with the `Scale_mul (resp.�`Scale_div) command.

val get_state : 'a t -> [ `Off | `Meas | `Meas_cont | `Event | `Reset ]

get_state us get the current state of the ultrasonic sensor us.

package mindstorm